corsair hydro series h80i v2 installation

Today, I will look at Corsair's new upper mid-range AIO, the Hydro Series H80i GT. When it comes to heatsinks and fans, Corsair really does have a product for just about everyone. Then there are the H100i and H110 for extreme cooling purposes as both were until recently the best the cooling line had to offer. The popularity Corsair enjoys in the PC-cooling market rests almost entirely on the Hydro Series of products which cover nearly every segment of the market from entry to enthusiast-the only thing missing is an expandable option. Let us not forget their fantastic support and exceptional warranties as these have made Corsair one of the go-to brands for almost anything PC related. They are a true market leader when it comes to PC parts and accessories, but great products and market penetration are only the tip of the iceberg. Corsair has products in nearly every conceivable category of the DIY PC market: air coolers, liquid coolers, power supplies, keyboards, mice, fans, cases, and memory. The radiator is very chunky and 2 fans make that doubly so.The only way for PC users to not have heard of Corsair is to have lived under a rock for the last decade. These are great coolers however make sure you have enough room to mount these as the 2 fans & radiator block must put the thickness at nearly 3.5 inches clearance needed (not measured actually). The temps are really low- 2 130 Watt CPU's running at a little over 30 degrees at full pelt. This gave me sufficient room to mount the fan & radiator but it also meant cutting into the case fittings with hand tools. The solution was to mount one of the coolers on the back of the case by removing a fan and then cutting between the 3 fan mounts on the top of the case. The radiator was either colliding with the ATX cables or the holes would not line up. No matter where I positioned the cooler assembly I could not get it to fit in one of the 120 mm radiator slots on top of the case. However I also have a large motherboard which is the ASUS Work station board which is extended ATX. I have a very large case, an old COSMOS 2. I don't know if the supplied ready applied TIM is any good but why take the risk as I know MX-4 is really good. I scrapped off the supplied TIM & used MX-4 on the CPU. LGA2011 fitting is very easy as it just needs 4 stand offs on the LGA 2011 mounting frame- so no fiddling with the rear of the board fitting any new frames. Excellent high quality product with some caveats I purchased 2 of these coolers as part of an upgrade to fit two Intel E5 2967 CPU's.

Corsair hydro series h80i v2 installation